Brake Pad Replacement — RAM 1500 DIY Guide

Replacing brake pads is one of the most cost-effective DIY repairs. With basic tools and 90 minutes you can save $200+ in labor. On the RAM 1500 (1981-present), this job typically takes about 90 minutes and uses 3.6L Pentastar V6 eTorque-spec parts.

Symptoms

• Squealing or grinding when braking
• Longer stopping distances
• Vibrating brake pedal
• Brake warning light

Tools

• Jack and jack stands
• Lug wrench
• C-clamp or piston tool
• Socket set (14mm/15mm)
• Brake cleaner spray

Steps

1. Loosen the lug nuts: With the car still on the ground, break the lug nuts loose with a half-turn. This is much easier before the wheel is off the ground.
2. Lift and secure the vehicle: Jack up the car at the manufacturer's lift point and place jack stands under the frame. Never work under a car held only by a jack.
3. Remove the wheel: Take the lug nuts off and pull the wheel straight off. Set it under the car as a backup safety measure.
4. Remove the brake caliper: Locate the two caliper bolts on the back of the caliper. Remove the bottom one first, swing the caliper up, and hang it from the suspension with a wire — never let it hang from the brake hose.
5. Slide out the old pads: The pads slide out of the caliper bracket. Note their orientation; they go back the same way.
6. Compress the caliper piston: Use a C-clamp against the old inner pad to push the piston back into the caliper bore. This makes room for the thicker new pads. Pop your brake fluid reservoir cap first so fluid can rise.
7. Install the new pads: Apply a thin layer of brake grease to the slide pins and back of the new pads. Slide them into the bracket in the same orientation as the old ones.
8. Reinstall the caliper and wheel: Lower the caliper over the new pads and torque the bolts to spec (usually 25-35 ft-lbs). Reinstall the wheel and lower the car.
9. Pump the brake pedal: Before driving, pump the brake pedal 10-15 times until it feels firm. This seats the pads against the rotor. Take a slow test drive and bed in the pads with 5-6 moderate stops from 35 mph.

Safety Notes

• Never let the caliper hang by the brake hose
• Always work on jack stands, not a jack alone
• Open the brake fluid reservoir before compressing the piston

FAQ

What's the lug nut torque spec for the RAM 1500?

130 ft-lbs in a star pattern. Always finish with a torque wrench, never an impact gun.

What engines does the RAM 1500 use, and does that change this job?

Common RAM 1500 engines include 3.6L Pentastar V6 eTorque, 5.7L HEMI V8 eTorque, 3.0L EcoDiesel V6. The procedure is the same across engines, but oil capacity and torque values may vary — confirm against your owner's manual before final assembly.

Are there known RAM 1500 issues to watch for during this job?

Yes — the most common RAM 1500 issues to inspect are: HEMI MDS lifter ticking and failure; Air suspension compressor failure; Cracked exhaust manifolds. While you have the wheel off or the engine open, take 60 seconds to look for these.

How often should I replace brake pads?

Most pads last 30,000-70,000 miles depending on driving style. City driving wears them faster than highway driving.

Do I need to replace the rotors too?

Inspect rotors for deep grooves or warping. If they're below the minimum thickness stamped on the rotor, replace them. Otherwise they can be reused or resurfaced.

Can I drive immediately after replacing pads?

Yes, after pumping the pedal until firm. Avoid hard stops for the first 200 miles to let the pads bed in properly.